Vitrulan VPP200

Vitrulan VPP200 is a non-woven glass fleece made from ultra-fine glass fibers. It’s applied beneath paint to reinforce wall and ceiling surfaces. Once installed, it’s invisible—but its benefits are anything but.

• Prevents cracking: Homes naturally shift over time, and minor wall cracks are a common result. VPP200 helps absorb movement and bridges small cracks before they become visible.

• Smooth, flawless surfaces: Ideal for both new builds and renovations, it evens out surface imperfections to create a clean, uniform base for painting or finishing.

• Long-lasting durability: Glass fleece is stronger than traditional liners, offering excellent resistance to wear and tear—perfect for busy households with children or pets.

• Easy to repaint: Thinking ahead to your next colour change? VPP200 makes it easy to repaint without needing to strip or resurface the wall. Less prep, less mess.

• Safe & eco-friendly: Made from non-toxic, fire-resistant materials, it supports a healthier indoor environment and meets high environmental standards.

• Living rooms and bedrooms

• Kitchens and bathrooms

• Hallways, staircases, and entryways

• Any area where smooth, crack-resistant walls are a must

Place an order today. If you have any questions then please get in touch with us to learn more or request a quote.

Wall surfaces to be covered with Vitrulan Glass Deco Fabric must be smooth, dry, sound, clean and free of contamination.

Highly absorbent surfaces should be primed using a high quality primer sealer. We would recommend that a ready mixed, red top adhesive be used to hang a glass fabric wallcovering. The Henkel Solvite High Performance product is ideal.

Please paste the wall, never the glass fleece. We would also recommend that the box is cut down and used as a trough to dispense the VPP200.

The back of the VPP200 is denoted by a strip of measurement marks denoting 10cm & 50cm measurements.

If you are not used to working with glass fabric wall covering we would recommend you wear gloves.

Apply approximately 200grams of adhesive per M2. Use a medium pile roller. Position the fabric edge to edge on the wall.

Vitrulan VPP200 can easily be overlapped and spliced, when doing so please ensure that all joints are perfectly flush and not raised.

Remove air bubbles using a spatula and press the fabric firmly into the adhesive.

In order to obtain uniform surface appearance ensure the same face of the fabric is always positioned uppermost

Trimming:

Trimming at the top, bottom and around doors and other apertures should be done immediately after the fabric has been positioned. Use scissors, or a sharp blade together with a steel straight edge.

External corners:

When taking VPP200 around an external corner, lightly pass some wet & dry over the fleece, which will allow it to bend around 90 degrees without popping either side of the corner.

If the external corner is poor, please treat the VPP200 as you would a heavy lining paper. Cut at 45 degrees at the external corner

Internal corners:

Take into the corner and cut. Do not wrap around an internal corner. The VPP200 will become far more malleable if flushed or misted with water.

Any defects, creases or joints which are not flush can be sanded out, once fully dry.

Temperatures:

Air and surface temperature must be 5°C or greater.

AREAS DECORATED WITH VITRULAN GLASS DECO FABRIC MUST BE ALLOWED TO DRY FOR A MINIMUM OF 12 HOURS BEFORE OVERCOATING.

First coat:

Application of paint should be with a roller or Airless spray application.

First cut in all the edges with a small roller /brush application. Then using a 9” Roller fill in large areas. Glass fabrics do have a tendency to absorb more paint than anticipated.

Second Coat:

As above.

Each roll of VPP200 is supplied with hanging instructions.